No. 353 Carbide Grout Saw

This hand saw is used for removing old or damaged grout. The angled steel handle bracket keeps the hand from contacting the floor during the sawing motion. Comes with one carbide blade coated with carbide grit for cutting out grout between tiles, and one steel-toothed blade for heavy cleanout work after using the carbide blade. The steel-toothed blade can be used in combination with the carbide blade for wider grout joints or to protect walls when removing grout close up to a wall. Minimum grout joint width: 1/8”. Net weight: 4 oz.

No. 353Y Grout Saw Replacement Blades (2)

This hand saw is used for removing old or damaged grout. The angled steel handle bracket keeps the hand from contacting the floor during the sawing motion. Comes with one carbide blade coated with carbide grit for cutting out grout between tiles, and one steel-toothed blade for heavy cleanout work after using the carbide blade. The steel-toothed blade can be used in combination with the carbide blade for wider grout joints or to protect walls when removing grout close up to a wall. Minimum grout joint width: 1/8”. Net weight: 4 oz.

No. 356 Carbide Hole Saw

This tungsten carbide hole saw works with a drill (not included) to cut clean 1 3/8” holes for pipe clearance. Works well on ceramic and soft-bodied quarry tile. The replaceable 1/4” masonry bit holds a center. An internal spring ejects the cut piece cut. Net weight: 10 oz.

No. 046 Replacement Carbide Wheel

The No. 046 is a replacement carbide wheel for the Crain No. 045 Super Quarry Tile Cutter only. It will not fit on other Crain tile cutters. It is 7/8” diameter x .080″ thick with a .260″ diameter center hole. No fasteners are included with this carbide wheel. Net weight: 1 oz.

No. 400 ½” Carbide Wheel

The No. 400 is a replacement carbide wheel for Crain Nos. 030, 031, 032X, and 033X Ceramic Tile Cutters. It is approximately 1/2” in diameter x .075″ thick with a 1/4” diameter center hole Replacement fasteners including a steel bushing, washer, screw and lock nut are included with this carbide wheel. Net weight: 1 oz.

No. 081 10” RemGrit® Hacksaw Blade

RemGrit® hacksaw blades are made by bonding carbide to a 10″ steel rod that fits most hacksaw frames. In a hacksaw, they can cut curves and straight lines in ceramic tile, brick, or marble, and can work in tight areas. Cuts equally well on both outward and inward strokes the saw. Hacksaw not included. Net weight: 1/2 oz.